Subaru WRX Forums banner
21 - 23 of 23 Posts

·
Registered
Joined
·
98 Posts
well since this is now a one man show it seems.

I have:
2011 WRX front axles
WL KCA313 Roll Center Kit

I ordered:
20202FG042
20202FG052 (part #s changed again)
2x 901000377
2x 34160XA010 (09-13 Forester X/XT inner tie rod)
2x 34127AG000 (WRX tie rod lock washer)
4x Kartboy front endlink spacers. (seeing if i can get by with this method for now, i may have to change sway bars)
 

·
Registered
Joined
·
98 Posts
got my control arms from Subaru (along with everything else i purchased)




dont try to take the boots off like i did for this pic. it was a royal pain in the ass getting them back on properly. if they arent PERFECT the boots will pop off through movement.

i will have direct comparisons between these and the 08-10 arms. since no one seems to know FOR SURE the dimensional differences. mainly exactly how much longer these are. so far all ive been able to work with is the track width difference numbers, but i dont know how much difference there is in the hub assembly (if any).

so for now, the plan is to use these LCAs, with 2011 WRX axles (should be longer) and the forester inner tie rods (should be longer). you cant use the STi inners apparently because the STi has a larger thread.
 

·
Registered
Joined
·
1 Posts
well since this is now a one man show it seems.

I have:
2011 WRX front axles
WL KCA313 Roll Center Kit

I ordered:
20202FG042
20202FG052 (part #s changed again)
2x 901000377
2x 34160XA010 (09-13 Forester X/XT inner tie rod)
2x 34127AG000 (WRX tie rod lock washer)
4x Kartboy front endlink spacers. (seeing if i can get by with this method for now, i may have to change sway bars)
Do you still have the lower arm LH
 
21 - 23 of 23 Posts
Top