Subaru WRX Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi their im building a v8 wrx and im running 18x11z all round and the wheels are 5x114 and i am using 15mm adapters az my stud pattern is 5x 100 but wheels are 15mm give or take out side the gaurds i have cut and pumped widebody all ready and dont want to have to do it again i was wondering if i could re drill the wheels and lose the adapters would this be possible and if any 1 has done this or have other ideas

Sent from my SM-G950F using Tapatalk
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top